Views: 7 Author: Site Editor Publish Time: 2020-07-24 Origin: Site
Insufficient pressure sprayer and poor atomization: If the water inlet ball valve is set up by dirt, the inlet valve can be removed and the dirt can be removed with a cloth; if the cup is damaged, a new cup can be replaced; if the connection part is not installed The sealing ring, or the air leakage due to the damage of the sealing ring, can be installed or replaced.
No fogging: if the oblique hole of the nozzle body is blocked by dirt, the oblique hole can be cleared; if the nozzle hole is blocked, the nozzle hole can be removed and cleaned, but hard objects such as iron wire or copper needle can not be used to poke the nozzle hole to prevent the hole from expanding , Make the spray quality worse; if the filter screen in the casing is blocked or the water valve ball is set up, the filter screen and the dirt that set up the ball should be cleaned.
The switch leaks or cannot be screwed: if the switch cap is not tightened, the switch cap should be tightened; if the gasket on the switch core is worn out, the gasket should be replaced; the switch cannot be screwed because it has been placed for a long time or used for a long time, the switch The core is stuck due to the corrosion of the agent. The parts should be removed and cleaned in kerosene or diesel; if it is difficult to remove it, it can be soaked in kerosene for a period of time, and then it can be removed after disassembly. Do not hit with hard objects.
Water leakage in each connection: If the joint is loose, the nut should be tightened; if the washer is not flat or damaged, the washer should be flat or replaced; if the washer shrinks and hardens, it can be soaked in animal oil before use